RadiSys ATCA-4616 Specifikace stáhnout pdf (Strana 121)

Troubleshooting

121

Troubleshooting Shelf Manager issues

General issues

Whenyouencounterproblemsrelatedtoshelfmanagement,checkthefollowingitemsfirst:

Make sure the Shelf Manager module is installed properly

MakesurethemodulerunningtheShelfManagersoftwareisintheRadisysshelfandseated

properly.

Make sure a proxy FRU is installed properly

MakesureatleastoneproxyFRUisintheRadisysshelfandseatedproperly.TheproxyFRUs

foreachshelfare:

ATCA‐6000:TheSPMslocatedintherearslotsbehindtheSCMs

ATCA‐6006:ThePEMslocate dattherearoftheshelf

ATCA‐6014andATCA‐6016:TheRCMslocatedinthefronthoriz ontalslotsatthebottom.

Important:DonotremovebothproxyFRUsatthesametime.

Make sure the Shelf Manager module’s ejector latches are fully closed

MakesuretheShelfManagermodule’sejectorlatchesareclosedfullyandthatthebluehot‐

swapLEDisoff.

•Ifthelatchesareclosedbutthebluehot‐swapLEDisflashing,shelfmanagementmay

havebeendisabledatthefactory .CheckwithyourRadisysrepresentativeifyoususpect

this.

•Ifthebluehot‐swapLEDison,thelatchesmaynotbeseatedproperly.Tryopeningthe

latchesandthenclosingthemagain.Thebluehot‐swapLEDshouldflashforafewseconds

afterthelatchesareclosedbeforeturningoff.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 145 146

Žádné komentáře

RadiSys ATCA-4616 Specifikace Strana 121